Section IV Performance – Gaming
Gaming as a test of motherboard performance is sort of a joke these days. The big player in the gaming arena is the GPU. Everyone but a few hardcore PR teams know this. However, it is important to run at least a few (one from each current DX version) to see if there are any issues with the combination of components on a motherboard. These are items like Audio lag, memory lag and of course problems with the PCIe lanes and signal traces. If there are issues in design, drivers or BIOS then you can have odd gaming performance. So without much more preamble let’s dive into the three games we currently use; Call of Duty Modern Warfare 2 for DX9 FarCry 2 for DX10 and Battlefield Bad Company 2 for DX11.
Call of Duty Modern Warfare 2 DX9 -
This is an excellent but short game that put you right into the action from the beginning and does not let up the pressure until the very end. The graphics are a little better; most notably the night and thermal imaging have been improved. The AI is still the typical COD “bar fight” style AI, with maybe a tad more finesse. All in all it is not a bad game to play and a decent one to use for testing. Our testing run starts at the bridge and ends after you clear the school in the first level of the game. Settings are shown below as are the performance numbers.
 |
 |
 |
 |
The numbers here are rather boring. All of the boards (with the hardware as configured) are more than a match for Modern Warfare 2. Yes we can call a winner but with 5FPS difference at almost 90FPS minimum I doubt you would notice. Still we have to say that the RIIIE came in second place here.
FarCry2 DX10 -
Although not one of my favorite games this tedious game does have some good graphics. The large sandbox style of the game lends to mission based play. The only problem is that the AI is rather low grade. Still the more CPU power the more the bad guys try to do. Over all the game was a little bit of a disappointment to play, but still not a bad DX10 representation. Our testing run starts right after you get your first mission to clean out the safe-house and ends after the hostage rescue. Settings and performance numbers are shown below.
 |
 |
Ugh these numbers are even more boring than the MW2 numbers. The delta from first to last is around 5-6 FPS and all of the boards are still over 32FPS; which is considered full motion by most. The RIIE manages to squeak by with a 1 FPS lead at stock and a 4 FPS lead when overclocked. Again if you saw these boards side by side you would never know.
Battlefield Bad Company2 DX11 –
I have liked many of the Battlefield games. They usually tend to be fast paced and fun. With Battlefield Bad Company 2 you do get some of that, but there is something about the graphics and the movement that just does not sit right. The AI is a less sophisticated form of the bar fight AI, but it gets the job done. Still, the game is good for testing as it can put a strain on the components of the board. Out testing run is the entire first level, from beginning to end. Settings are shown below along with the raw numbers.
 |
 |
Again we see more of the same. The numbers are very close together. Yes there is one board that performed better than the others (in this case the P6X58D at stock and the MSI Xpower when overclocked) but there is not enough of a margin to make it anything of note.
Gaming wrap-up;
In the end our three gaming test show us that the Asus Republic of Gamers Rampage III Extreme can handle gaming at stock and overclocked speeds. You are not going to have to worry about any component, driver or BIOS issues affecting your gaming ability.
